Digital temperature sensor ZET 7021
- Type of sensors connected: thermal resistance
- RS-485 data interface
- Ready for operation
POR (price on request)
* Minimum order value: from 7 700 USD
Specifications
of digital temperature sensors ZET 7021
Metrological perfomance | |
---|---|
Measured value | temperature |
Sensitivity threshold (minimum difference value between two consequtively measured values) | 0,001 °C |
Absolute measuring tolerance (with a thermal resistance of AA class) | ±0,1 °C |
Relative measuring tolerance (from the measured value) | 0,05 % |
Additional measuring tolerance (depending on temperature changes) | 0,05 %/ 10°C |
Technical specifications | |
Nominal static characteristics of connected primary transducers | 100P(0,00391), 50P(0,00391), Pt100(0,00385), Pt50(0,00385), 100M(0,00428), 50M(0,00428), Cu100(0,00426), Cu50(0,00426), 100H(0,00617), 50H(0,00617) |
Signal measurement range of resistance from primary transducer | from 0,2 up to 450 Ohm |
Refresh rate | 1 Hz |
Data interface | RS-485 |
Data rate | 4800, 9600, 14400, 19200, 38400, 57600, 115200 bit/s |
Parity control | 0 – no control, 1 – control (oddity, ODD) |
Data communication protocol | Modbus RTU |
Operational parameters | |
Dimensions | 71×39×17 mm |
Weight | 35 g |
Device power | 9 – 24 V |
Power consumption | 0,5 W |
Reverse polarity protection | yes |
Operation temperature range* | from -40 up to +100 °C |
Electromagnetic compatibility | |
MEK 61000-4-2 (IEC 61000-4-2), ESD | contact 4 kV, air 8 kV |
MEK 61000-4-4 (IEC 61000-4-4), EFT | power 0,5 kV, signal 0,25 kV |
MEK 61000-4-5 (IEC 61000-4-5), Surge | 500 V |
* Operation measurement temperature range is detrmined by characteristics of the connected thermal resistance
Parity control in the EVEN mode is not supported. Modbus ASCII is not supported.